How do I use the Garrett AT Max?

Question: How do I use the Garrett AT Max?

Answer: 1. Power ON. Press the ON / OFF Power button for 1 second. The AT Max powers on in the last mode used and is ready to search. The detector operates with four (4) AA batteries which are already installed by Garrett.

2. Select Mode. Use the Mode button to select a different detection mode, when desired. (Factory default mode is Coins.)

3. Adjust settings. Adjust Sensitivity, Threshold, Volume, or Discrimination settings, if desired.

4. Begin scanning. Lower the searchcoil to approximately 1 inch above the ground and scan the coil left and right at approximately 3 ft/second. The coil must be in motion for target detection, but can remain stationary during Pinpoint.

Relevant to: 

• Garrett AT Max Metal Detector with Z-Lynk